Use kit 96546 for RIGHT SIDE application

Use kit 96545 for LEFT SIDE application

Including:

• Complete ModulT DBT22LT Air disc brake without brake pads.

Find corresponding brake pad kit for this JOST application here

Help for maintenance

Initial procedure

1. Remove brake pads
2. Remove actuator
3. Remove disc brake unit
4. Remove sliding function kit
5. Remove mechanism seal
6. Install mechanism seal
7. Install sliding function kit
8. Install disc brake unit
9. Install actuator
10. Install brake pads
11. Replace reset shaft kit

Function test

Final procedure

Tightening torques

• Sliding pins screws: 180 Nm + 70°
• Brake chamber fixation nuts: 180 ±20 Nm
• PWS/PWIS screw: 24 Nm
• Fitting screws on the axle : always follow the vehicle/axle manufacturer's recommendations!