Use kit 95399 for mechanism seal replacement

Including :

• 1 plug
• 1 Bellow
• 1 Grease tube

Help for maintenance

Initial procedure

1. Remove brake pads
2. Remove actuator
3. Remove disc brake unit
4. Remove sliding function kit
5. Remove mechanism seal
6. Install mechanism seal
7. Install sliding function kit
8. Install disc brake unit
9. Install actuator
10. Install brake pads
11. Replace adjustment shaft kit

Function test

Final procedure

Tightening torques

• Sliding pins screws: 180 Nm + 70°
• Brake chamber fixation nuts: 180 ±20 Nm
• PWS/PWIS screw: 24 Nm
• Fitting screws on the axle : always follow the vehicle/axle manufacturer's recommendations!