General

Leveling Valve - With Height Limitation

Adjustment of height limitation

The chassis height of the vehicle is a function of the lever length and the rotation angle at the shaft of the levelling valve (measured in degree°). Thus the height limitation is not set by an travel (mm) but by an angle (°). How these angle the lever length and the change of the chassis height is linked together you can see in the "chart for height limitation" (here shown for 45° as an example).
The height limitation can be set over a range of α = 15° to 50°. If the factory-set height limitation of α = 45° ±2° needs to be changed, the dump valve must be removed (using SW 13) and the adjuster screw turned with a suitable tool (904 054 001).

  • Clockwise rotation: α < 45°
  • Anticlockwise rotation: α > 45°

The angle here refers to the downwards excursion “α” of the control lever from the horizontal, in degrees. After setting please refit the dump valve.

Chart for height limitation

  Linkage distance (mm)  
Deflection 60 80 100 120 140 160 180 200 220 240 260 280 300 320  
α = 45° 42 56 70 84 99 113 127 141 156 170 184 198 212 226 Height change (mm)

Inspection

  • Test for operation and leaks.
  • The pressure should neither rise nor fall at the delivery ports in the neutral position.
  • Check the linkage moves freely and is in good condition, replace if bent or welded.
  • Replace hardened or brittle rubber parts.

Maintenance

  • If defects are noted during vehicle examinations or when driving, then the unit should be exchanged.
  • When working with high pressure cleaners a distance of at least 50 cm should be observed.
  • Missing exhaust caps are to be renewed.

Technical data

Medium Air
Operating pressure, dynamic 13 bar
Max. permissible bellow pressure 20 bar
Working range (charging/discharging) 45°
Operating side left and right
Tightening torque ports (thread M12x1.5) 12 - 15 Nm
Tightening torque ports (thread M16x1.5) 20 - 25 Nm
Tightening torque for fixing the body 20 + 2 Nm
Tightening torque for fixing
the linkage (wrench size 10)
8 Nm
Tightening torque for fixing
the linkage (wrench size 13)
15 - 20 Nm
Ports 1, 12 Supply
Ports 21, 22, 23 Delivery
Port 3 Exhaust

Sectional drawing 612 032 xxx

Technical symbol

Ports: 1, 12 - Reservoir / 21, 22 - Suspension / 23 - Supply / 3 - Exhaust

Symbol used in drawings