Maintenance
The service manual can be downloaded from the documentation page. This document is intended for the exclusive use of trained personnel within the commercial vehicle industry and related workshops. The service manual also contains guidelines on how to carry out initial and final procedures in a standardised manner. To complement this document, we offer below 3D animation that show you how to service your ModulT air disc brake.
Replacement procedures
ModulT Initial Procedure
ModulT GenI Pad replacement
ModulT GenII Pad replacement
Remove Actuator
ModulT remove disc brake unit
Remove sliding function kit
Remove mechanism seal
Installation procedures
Install mechanism seal
Install sliding function kit
Install disc brake unit
Install actuator
Install brake pads GenI
Install brake pads GenII
Replace reset shaft kit
Function test and final procedure
ModulT Function Test
ModulT Final Procedure
Tightening torques
- Sliding pins screws: 180 Nm + 70°
- Brake chamber fixation nuts: 180 ±20 Nm
- PWS/PWIS screw: 24 Nm
- Fitting screws on the axle: always follow the vehicle/axle manufacturer's recommendations!