DIN Aux splitter

Aquí encontrará una descripción ampliada, vistas de los conectores y ayuda para el diagnóstico.

Description

Pin	Description	Color	Section (mm²)
1	Output	Red	0.75
2	Ground	Black	0.75
3	not used	-	-
4	not used	-	-

This Auxiliary splitter cable can be used for an parallel output (2xILAS-E, 2xCOLAS, ...), both being powered at the same time.

OUTPUT AUX
Test points	Condition	Required value	Measured value	Comments
1 - 2 Red - Black	Output is ON	B+		If the measured value is below B+, it can indicate a resistance in the wiring. Next steps : check for oxidation marks in the connectors check the continuity of the wires with ohmmeter (R<5Ω for correct operation) check the solenoid (Colas, Ilas-E, ...)
1 - 2 Red - Black	Output is OFF	5V (detection voltage)		The ECU use this low voltage to determine if a load (solenoid) is connected or not. Next steps : check for oxidation marks in the connectors check the continuity of the wires with ohmmeter (R<5Ω for correct operation)

OUTPUT AUX

Test points

Condition

Required value

Measured value

Comments

1 - 2

Red - Black

Output is ON

B+

If the measured value is below B+, it can indicate a resistance in the wiring.

Next steps :

1 - 2

Red - Black

Output is OFF

5V (detection voltage)

The ECU use this low voltage to determine if a load (solenoid) is connected or not.

Next steps :