Haldex
SUMS
Electronic Braking Systems
ABS
Brake Components
Actuadores
Air Suspension
Frenos de disco neumáticos
Brake Adjuster
Software
Esquemas eléctricos de frenos y suspensión

U-ABS 24N AM to Power-B

Aquí encontrará una descripción ampliada, vistas de los conectores y ayuda para el diagnóstico.

 

Description

  • Conforms to IP67 when mated with U-ABS ECU and ABS Framatome connection
  • Cable insulation material : PVC

Framatome plug

24N AM plug.png

Pin Description Color Section (mm2)
1 B+ Red 1.5
2 Lamp Black 1.5
3 B- White 1.5
4 - - -

Power-B plug

U-ABS Power-B plug ok.png

Pin Description Color Section (mm2)
1 B+ Red 1.5
2

Lamp

 Black 1.5
3 B- White 1.5

Diagnostic

Power-B is an optional back-up power in EU. But in some countries, it is the main powering of U-ABS (i.e. Brazil).

When switching power ON, with trailer brakes applied, vehicle at rest

  • Each modulator exhausts one time (the number of exhausts must be the same as the number of modulators).
  • ABS warning lamp on dashboard or trailer indicates a specific sequence (ON/OFF) or (ON/OFF/ON)

If not, check power supply :

Test points

(with 21W lamp)

 Condition Required value Measured value Comments

Power-B plug

1 - 3

 

ISO1185 connected

Stop lamps ON

 B+ Stop lamp  

If measured value is below B+ (voltage drop), it can indicate a resistance in the wiring.

Next steps :

  • check for oxidation marks in the connectors
  • check stop lamp signal in the connection box
  • check the continuity of the wires with ohmmeter between connection box/connectors and ECU plug. (R<5Ω for correct operation)

Power-B plug

1 - 3

ISO1185 connected

Stop lamps OFF

0V

  

A permanent power indicates a wrong wiring or short circuit.

Next steps :

  • check for oxidation marks in the connectors
  • check the wire position in the connection box
  • check isolation between wires with ohmmeter